Buy Edelbrock 1409 Performer Series Marine 600 CFM Square Bore 4-Barrel Air Valve Secondary Electric Choke New CarburetorEdelbrock 1409 Performer Series Marine 600 CFM Square Bore 4-Barrel Air Valve Secondary Electric Choke New Carburetor Product Description:
- Designed and calibrated for optimum marine performance
- Single feed fuel inlet with air valve secondary type
- Shiny silver finish and calibrated for gasoline
- No power valves to blow or plastic parts to break
- Backed by Edelbrock's exclusive 90 day warranty
Product Description
The Edelbrock Performer Series Marine Square Bore Air Valve Secondary Electric Choke New Carburetor features modified bowl venting, specially designed throttle shafts, accelerator pump seal, 3/8 inch inverted flare fuel inlet fitting, tube in air horn for fuel pump vent, 5-1/8 inch flame arrestor flange, universal throttle lever and a revised secondary system for improved transient performance in marine applications. The Edelbrock square-bore carburetors are all-aluminum, ball-burnished and lightweight. There are no power valves to blow or plastic parts to break. The two-piece construction resists warping. Metering rods can be changed within seconds without carburetor removal. Their simple tub-type bowl and rear-pivot floats offer you trouble-free operation. The Edelbrock Performer warranty covers the replacement or repair of the product only and does not cover the cost of removal and installation.
Customer Reviews
Most helpful customer reviews
6 of 6 people found the following review helpful.
Quite an improvement
By Gary E. Gilroy
I replaced a rochester quadrajet carb with this one and the difference is terrific. It was a breeze to install, only having to modify the fuel line and the electric choke which was easy. Took it on a trial run yesterday and boat ran excellent with carb adjustments left as they were right out of the box. I'll dial it in next time and expect it to be even better. I will never buy another rochester again. They just dont compare with this one.
0 of 0 people found the following review helpful.
Carb Replacement
By foxskir
I was getting tired of rebuilding my 1995 vintage 4-barrel Carter/Weber carburetor every season or two. Each rebuild kit was around $80. So I researched my replacement options and chose the Edelbrock 1409 Marine Series Carb. Some reviews said that right out of the box the motor would run fine. They were right. All I had to do was adjust the idle speed slightly. Boat runs great.
0 of 0 people found the following review helpful.
Nice carb
By Michael Butterfield
Not sure if I read somewhere that the carb comes completely "setup." Anyway, took one or two times with the boat out to get it right. Nevertheless, if you are looking to get rid of that old weber or whatnot, this was a bolt-on application, but please read my comment below.I do want to caution you though!! If you have to by the spread bore to square bore conversion kit...Edelbrock absolutely gives you the wrong hardware. The hardware they give you is identical to the original! If you are buying a conversion kit (basically a spacer), doesn't make sense that the height of the hardware will increase by the height of the spacer? Since Edelbrock makes the carb and the conversion kit, don't you think they would be able to get this right? Ran around 3 hours getting the right hardware and 20 minutes installing the carb.
See all 3 customer reviews...Latest Price:
See on Amazon.com!
More Info:
See on Amazon.com!
See Customers Review:
See on Amazon.com!
Buy Grant 714 Wheel Silver Satin 14In
